Anthracite Filter Media – 0.8–1.2 mm | UV Water Systems Oman

Dual-media filtration — combining anthracite coal on top with silica sand below — is one of the most cost-effective improvements to a conventional single-media sand filter. In a single-media sand filter, most suspended solid removal occurs in the top 20–30% of the bed. The lower portion acts primarily as a support zone and contributes little to filtration efficiency. By adding a layer of lower-density anthracite coal above the sand, the media bed uses its full depth for filtration.

Anthracite’s larger particle size and lower density place it naturally above finer, denser sand after backwash, creating a filter that works from the top with the coarsest media and progressively finer media toward the bottom — the ideal configuration for depth filtration. The anthracite filter media supplied by UV Water Systems in Muscat is graded to 0.8–1.2 mm for use as the upper layer in dual-media and multi-media pressure filters across Oman.

How Anthracite Improves Filter Performance

In a dual-media filter, anthracite (specific gravity 1.4–1.6) sits above silica sand (specific gravity 2.65) after backwash because it is lighter. Water flowing downward first encounters the coarser anthracite layer, which removes the bulk of suspended solids and turbidity. The finer sand layer below then polishes the partially clarified water, removing smaller particles. This graded removal distributes the solids loading across the full bed depth, dramatically increasing the total dirt-holding capacity of the filter and extending run times between backwashes. For Oman’s water treatment systems, where frequent backwashing consumes product water and stresses control valve components, longer filter runs have real operational and economic benefits.

Key Features and Benefits

Increased dirt-holding capacity: Dual-media beds with anthracite over sand hold 2–3 times more suspended solids per unit area compared to single-media sand filters of the same depth, significantly extending filter run times.
Full-depth filtration: Anthracite’s larger pore size captures large particles in the upper zone while the sand below captures fine particles — the entire bed depth contributes to filtration rather than just the top portion.
Natural stratification after backwash: Anthracite’s lower density causes it to settle above sand automatically after backwash without manual intervention — the graded bed structure regenerates itself with each backwash cycle.
Lower pressure drop: The coarser anthracite layer has higher porosity and lower flow resistance than an equivalent depth of sand, reducing the energy requirement for water to pass through the filter at design flow rate.
Compatible with all standard FRP vessels: Anthracite is loaded in the same FRP pressure vessels and uses the same multi-port control valves as single-media sand filters — no vessel modifications required for conversion to dual-media.

Technical Specifications

Particle size: 0.8–1.2 mm effective diameter
Uniformity coefficient: ≤1.7
Specific gravity: 1.4–1.6
Ash content: ≤12%
Bed depth: 400–600 mm above sand layer
Quality: ISO 9001:2015 certified supply chain

Applications Across Oman

Anthracite dual-media filtration is used in Oman’s water treatment pre-treatment systems where high turbidity feed water — from surface sources, treated effluent, or high-iron well water — requires greater dirt-holding capacity than single-media sand filtration provides. UV Water Systems supplies anthracite and designs dual-media and multi-media filter systems for commercial and industrial clients throughout Muscat and Oman.

Frequently Asked Questions

What is the typical anthracite-to-sand depth ratio in a dual-media filter? A standard configuration uses 400–500 mm of anthracite above 200–300 mm of silica sand, with 150 mm of gravel support below the sand. UV Water Systems designs the media loading profile based on your feed water turbidity and target effluent quality.

Can I retrofit anthracite to an existing sand filter? Yes — removing the top 400–500 mm of sand and replacing it with anthracite converts a single-media filter to dual-media. UV Water Systems carries out media retrofits on existing filter vessels across Muscat. Call +968 9763 7786 for a site assessment.

UV Water Systems is an ISO 9001:2015 certified water treatment company based in Muscat, Sultanate of Oman, with 14+ years of experience. We supply, install, and service water treatment solutions for residential, commercial, and industrial clients across Oman. Call +968 9763 7786 or visit www.uvwater.biz.

Anthracite Filter Media Oman

Anthracite Filter Media 0.8-1.2mm – UV Water Systems Oman